Home » News » News » Requirements for materials for punching net

Requirements for materials for punching net

Views:12     Author:Site Editor     Publish Time: 2016-07-13      Origin:Site

A good surface quality, good surface quality of the material, when the sieve punching the workpiece is not easily broken, waste reduction; mold easy bruising, life expectancy increased, and good surface quality of the parts. Therefore, the general requirements for stamping surface smooth, almost whole, scale, crack, rust, scratches and other defects.
Second, in line with the thickness of the die gap tolerances national standard is determined by the thickness of the material, so the material thickness tolerances shall meet the standards prescribed by the State. Otherwise, the thickness tolerance is too large, it will affect the quality of the workpiece, and may cause damage to the mold and equipment.
Third, the good performance of punching punching plate punching performance refers to a variety of stamping sheet metal processing methods adaptability. Metal stamping method is based on a plastic processing methods, therefore, it requires materials with good ductility.
For plastic, required to allow deformation of the material to a large extent, you can reduce the number of sieve stamping process and intermediate annealing times. For the separation step also requires a certain degree of plasticity, while the yield limit of the material requires slightly higher, get higher quality rear section to facilitate punching.

CONTACT US

   Add: Wire Mesh Induatrial Zone,Anping,China
  Post Code: 053600
  Tel: +86-318-7750658
   Fax: +86-318-7022622
  WhatsAPP: +86-15931384223
  Email: sales@wiremesh-yld.cn

Scan to join us

Anping Yilida Metal Wire Mesh Co.,Ltd.
Copyright © 2016 Anping Yilida Metal Wire Mesh Co.,Ltd.   All rights reserved.